MODEL : MW0700-038 | 40NC | 60NC | 80NC |
Nominal Size | Swing Over Bed | 400mm (17-5/16in) |
| Swing Over Cross Slide | 190mm (7-1/2in) |
| Hight Of Center | 220mm (8-5/8in) |
| Distance Between Center | 1000mm (40in) | 1500mm (60in) | 2000mm (80in) |
Bed | Width Of Bedways | 330mm (13in) |
| Total Length Of Bed | 2000mm (78in) | 2510mm (98in) | 3020mm (118in) |
| Swing Over Gap | 660mm (26in) |
| Length Of Gap | 300mm (11-3/4in) |
| Width In Front Of Face Plate | 190mm (7-1/2in) |
Spindle | Spindle Nose Mounting | D1-8 CAMLOCK |
| Spindle Bore | 86mm (3-3/8in) |
| Taper Of Spindle Bore | M.T. #7 (Sleeve M.T. #5) |
| Range Of Spindle Speeds | High 2000-240/ Middle 380-45/ Low 84-10RPM |
Slide | Cross Slide Travel (X Axis) (Ball Screw 25mm x 5mm C5) | 280mm (11in) |
| Rapid Travel (X Axis) | 6 m/min |
| X Axis Driver Motor | 29 Lb/in (Centroid) 7.3Nm AC servo (Fagor) |
| Longitudinal Travel ( Z Axis) (Ball Screw 40mm x 10mm C5) | 920mm (36-1/4in) | 1430mm (56-1/ 4in) | 1940mm (76-3/8in) |
| Rapid Travel (Z Axis) | 8 m/min |
| Z Axis Driver Motor | 29 Lb/in (Centroid) 7.3Nm AC servo (Fagor) | 40 Lb/in (Centroid) 9.3Nm AC servo (Fagor) |
Tooling | Max. Size culting tool | 25mm (1") (for quick change tool post) |
| Hydraulic Turret (optional) | 8 Tool Section (25mm for square tool, 40mm dia. for boring tool) |
| Electrical Turret (optional) | 6 Tool Section (20mm for square tool, 7/8in for boring tool) |
Tail | Tailstock Quill Diameter | 75mm (3in) |
| Tailstock Quill Taper | M.T. #5 |
| Tailstock Quill Travel | 160mm (6-5/16in) |
Motor | Main Spindle Motor | 10HP 7.5KW |
Weight | Machine Weight | 1800Kgs | 2000Kgs | 2300Kgs |
